|
Hemi Sync® CDs
Monroe Institute Products |
Hemi-Sync CDs are owned by Monroe Products.
Hemi-Sync CDs are developed by The Monroe Institute.
Hemi Sync is a patented technology of
Monroe Products.
Hemi Sync refers to hemispheric synchronization of brain waves.
Hemi-Sync Products: Metamusic®, Human Plus®, & Mind Food®
|
|
Mind machines:
Proteus, Procyon, Sirius, Minds Eye. CESUltra. Biofeedback: Healing Rhythms, ThoughtStream
|
|
|
|
|
Setting Up and Running Your
First Proteus Mind Machine Session
Step 1: Install the batteries
- Remove the sliding battery cover from the back of the Proteus.
- Install three "AA" batteries. Be sure to observe proper
orientation.
- Replace the battery cover.
Step 2: Connect the LiteFrames and headphones
- Plug the LiteFrames into the TOP of the unit.
- Plug the headphones into the jack on the RIGHT SIDE of the unit
that is NEAREST the TOP.
Step 3: Select a program
- Turn the unit on using the slide switch on the UPPER RIGHT SIDE
of the console. The display will briefly flash the installed
operating system version (2.0). If the first character on the
display is "P" then proceed to the next step. Otherwise, press the
middle (mode) button until the first character is "P".
- Press and hold the bottom button; notice that the display
increments sequentially: "P01", "P02," etc., indicating which program
has been selected. When the session you wish to run appears on the
display, release the button.
Step 4: Start the session and adjust brightness and volume
- Sit or lay down in a quiet, comfortable location. Press the
Start/Stop (top) button to start a program. Be sure to
close your eyes! You may also need to adjust the position of
the LiteFrames on your nose in order to obtain the best effect.
The light brightness and sound volume will fade in for the first eight
seconds. Adjust the brightness and volume via the two dials on
the top of the unit.
You can stop the session at any time by pressing the top button ONCE
to initiate a twelve-second "soft off" or TWICE to stop abruptly.
Press it three times to sop during the first eight seconds ("soft-on"
phase) of the program.
NOTE: Proteus will automatically shut itself off while not in
use, regardless of switch position. It has powered down while in
the ON position, you will need to slide the switch OFF and the ON again.
|
