|
|||||||
|
|
Section I ThoughtStream Biofeedback Machine Operation Guide This section tells you everything you need to know about using the ThoughtStream Performance Feedback System. If you want to use ThoughtStream right away, you can jump to the Quick Start instruction. The following sections provide all the information you need to get the most out of ThoughtStream.
Battery Installation ThoughtStream operates on three standard AA batteries. Slide open the battery compartment cover on the back of the unit. Install the batteries according to the polarity symbols (+ and -) marked on the inside of the compartment. NEVER leave weak or dead batteries in the unit as they can lead chemicals that can damage the unit. Keep an extra set of free batteries handy. Low battery display: When the batteries are low, the LEDs will flash red for 10 seconds and then turn off. Preparing ThoughtStream for use ThoughtStream has two control dials, a START/STOP button, and ON/OFF switch, an three inputs one for the sensors, one for the headphones, and one for the computer interface (optional). Using The Sensors
Your hands should be clean an dry before putting on the sensors. Place the band on with the metal contact facing toward the palm of your hand. Adjust the strap, it should fit snugly, but not so tight that it becomes uncomfortable. Keep the contact clean and dry at all times. For best performance you should occasionally clean them with denatured alcohol on a cotton swab.
|
||||||
